PRODUCT DETAILS

Aircraft Parameters

• Overall Weight: 38 kg (excluding battery), 50 kg (including battery).
• Maximum Takeoff Weight: 90 kg for spraying (near sea level), 101 kg for spreading (near sea level).
• Maximum Diagonal Wheelbase: 2184 mm.
• Dimensions: When the arms and propellers are unfolded, it is 2800 mm×3150 mm×780 mm; when the arms are unfolded and the propellers are folded, it is 1590 mm×1930 mm×780 mm; when the arms are folded, it is 1125 mm×750 mm×850 mm.
• Hovering Accuracy: When RTK positioning is enabled, it is ±10 cm horizontally and ±10 cm vertically; when RTK positioning is disabled, it is ±60 cm horizontally and ±30 cm vertically (±10 cm when the radar function is enabled).
• Maximum Configurable Flight Radius: 2000 m.
• Maximum Withstandable Wind Speed: 6 m/s.
• Maximum Flight Altitude: 30 m (as per the Draft Regulations on the Management of Unmanned Aerial Vehicle Flight).
• Maximum Flight Speed: 10 m/s, and the maximum operating flight speed is also 10 m/s.

Power System

• Motor: The stator size is 100×33 mm, the motor KV value is 48 RPM/V, and the motor power is 4000 W/rotor.
• Propellers: The diameter is 54 inches, and the number of rotors is 8, which adopt a coaxial dual - rotor design.

Spraying System

• Operation Tank: The operation tank has a volume of 40 L and an operation load of 40 kg.
• Water Pump: It is a magnetic - drive impeller pump, with a maximum flow rate of 6 L/min×2.
• Nozzles: The nozzle model is LX8060SZ, and the number of nozzles is 2. The atomization particle size is 50 - 500 μm, and the maximum effective spray width can reach 11 m (relative to an operating height of 2.5 m and a flight speed of 7 m/s).

Battery and Charging Details

• Battery: It uses a 30000 mAh intelligent flight battery, with a voltage of 52.22 V, supporting 11.5C discharge and 6C charging. The battery has a guaranteed 1500 - cycle life within the warranty period.
• Charging: It is equipped with a D12000iE all - in - one variable - frequency charging station, which adopts a new electronic injection technology, effectively saving 15% of fuel. The charging module can be separated independently, and it supports mains input (an additional AC module needs to be purchased). The charging station also supports 1500 W AC output. It only takes 9 minutes for a fast charge (charging from 20% to 95%). The charger has power - adaptive protection and supports three - phase 380V 9000W or single - phase 220V 3300W power supply.